| To check capacity and hammer performance on driven piles | Dynamic pile testing equipment | Sensors on the pile measure force and motion with each hammer blow. | A trained engineer should run the test and analyze the data. |
| To check a pile or shaft for defects | Low strain integrity tester | A light hammer tap and a sensor show changes along the shaft. | It is a screening test. Its reach depends on the pile and the soil. |
| To check the concrete in a drilled shaft | Thermal profiling or crosshole sonic logging equipment | Both find flaws in the shaft without coring. | Plan the wires or the access tubes before the cage goes in. |
| To check a shaft excavation before the pour | Shaft shape and base cleanliness tools | They measure the hole and the debris at the base. | Schedule the test between drilling and the pour. |
| To place piles accurately from a barge | GNSS pile positioning and guidance system | It shows the operator the pile position against the design in real time. | Check the correction source and the sensor setup on your rig. |
| To see the seabed or work underwater | Sonar and hydrographic survey system | It maps the bottom and shows structures you cannot see. | Match the sonar to the depth, the detail, and the vessel. |