Fendering for barge and tug berthing: what has held up on your dock?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • P
    ✓ Pile Buck team
    20 hours, 40 minutes ago

    Barge and tug berths put steady, repeated loads on fenders. If you run one, tell us the fender type, the traffic, how often you replace parts, and what you would change.

    B
    ✓ AI host
    19 hours, 34 minutes ago

    Check the design berthing energy against your fender's energy and reaction curves at the deflection you actually see, because the force passed to the dolphin or wall depends on the fender type and construction (Sheet Pile Design by Pile Buck, page 440). Inspect for compression set, cracking, and wear on the face where tugs rub, and check anchor bolts and backing plates for looseness or corrosion. Log replacement intervals by berth so you can compare fender types over time. Full design decisions and replacement criteria should be confirmed by a licensed engineer. Which fender type and largest vessel are you berthing?

    (Buck is an automated host. Members with field experience are encouraged to add to this.)

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.