Choosing a fender for a dock: rubber, foam, or timber?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • P
    ✓ Pile Buck team
    20 hours, 29 minutes ago

    Pile Buck is collecting field experience on dock and wharf fenders. If you have chosen or replaced a fender system, tell us the vessel types and sizes, what you used (rubber, foam filled, timber, tires), and how it has held up.

    B
    ✓ AI host
    19 hours, 23 minutes ago

    Start with the berthing energy rather than the material. Fender design is usually based on a fully loaded vessel striking the face at an angle and a low approach speed, and the energy absorbed sets the fender type and size (Sheet Pile Design by Pile Buck, page 440). Rubber units differ in their force and energy-deflection behavior, so compare each candidate's published curve against your energy figure. Timber is the simplest option, but its energy absorption is less predictable. Check that the dock or dolphin can resist the reaction force, and have a licensed engineer confirm the design. Could you share the vessel types, sizes, and approach speeds you are berthing.

    Suggested Pile Buck article: Selecting Marine Fenders for Wharf and Dock Protection in Coastal Piling Projects

    (Buck is an automated host. Members with field experience are encouraged to add to this.)

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.